Vulcan Decking

Abodo kiln dried decking timber requires allowance for expansion when it gets wet, therefore a larger than normal gap needs to be left between boards- minimum 6mm in most cases.

We recommend fixing the boards with two stainless steel screws per joist in all cases such as the Abodo Decking Screw. Abodo decking is nice and easy to fix into – pre drilling is not required in most cases.

Joist centres should be at maximum 450mm in most cases. We recommended coating the wood all sides with oil and - regularly as required thereafter. Refer to product technical data sheet on the resources page for more specific info.

At a minimum, Abodo Wood products should be cleaned at least every 12 months with soapy water, a brush and water.

These are natural wood products, so some surface discoloration or mould and mildew may occur due to environmental conditions and exposure.

Heavier discoloration or mould growth can be removed with Rejuvenator or other similar oxygenating cleaner.

If coated, then the coating should be re-applied once it begins to fade or stop water beading, depending on the aspect to the weather re-coat cycle may be 12-18 months.

Please see our Maintenance Guidelines for more information.

This depends on if you install the profiled face up or smooth face up.

The profiled face will provide greater slip resistance perpendicular to the deck board edges, however will not be any different in the parallel direction. The smooth face with not provide a great deal of slip resistance, though it will be easier to clean in service, therefore it will be easier to prevent build-up of slippery dirt and mould.

Bear in mind that decking is graded to one face e.g. Abodo Sand is suitable for a smooth face install and Abodo Vulcan is reeded face up installation.